Jeep Cherokee 2000 Service Manual page 1482

Hide thumbs Also See for Cherokee 2000:

Table of Contents

AUTOMATIC TRANSMISSION—30RH

DISASSEMBLY AND ASSEMBLY (Continued)

Fig. 185 Compressing Front Clutch Piston Spring

1 – FRONT CLUTCH SPRING

2 – COMPRESSOR TOOL C-3575–A

3 – RETAINER SNAP RING

4 – SPRING RETAINER

Fig. 186 Front Clutch Piston Installation

1 – CLUTCH PISTON

2 – FRONT CLUTCH RETAINER

(4) Remove top pressure plate, clutch discs, steel

plates, bottom pressure plate and wave snap ring

and wave spring (Fig. 190).

(5) Remove clutch piston with rotating motion.

(6) Remove and discard piston seals.

(7) Remove input shaft snap-ring (Fig. 191). It

may be necessary to press the input shaft in slightly

to relieve tension on the snap-ring

(8) Press input shaft out of retainer with shop

press and suitable size press tool. Use a suitably

Fig. 187 Clutch Piston Spring Installation

1 – RETAINER

2 – CLUTCH SPRING

Fig. 188 Correct Spring Retainer Installed Position

1 – SMALL TABS ON RETAINER FACE UPWARD

Fig. 189 Measuring Front Clutch Pack Clearance

1 – DIAL INDICATOR

2 – WAVED SNAP-RING

3 – FRONT CLUTCH

5 – GAUGE BAR

6 – PRESSURE PLATE

Troubleshooting