Leckey Mygo Max User Instructions page 14

9.3 Backrest Height
To adjust the overall height of the backrest
loosen the two screws in the middle of the
backrest, adjust to the required position and
retighten securely. The height can be fine
tuned with the user in the seat.
Use caution when adjusting to minimum
setting as fingers could become trapped
between moving and static parts.
9.4 Backrest Angle
To change the angle loosen the screw at the
bottom of the backrest spine, adjust to the
required position and retighten the screw
securely.
The backrest angle can be adjusted with the
user in the seat. The backrest spine has a
useful angle indicator designed to indicate
the preferred position or back angle for
different activities.
Hold the backrest spine with one hand
while you adjust the back angle.
9.5 Adjusting the upper
leg supports
The upper leg supports will be set at the
minimum position on arrival. Set the depth
before placing the child in the seat. Fine
adjustment is possible afterwards but is
restricted by the user's weight. To achieve
the correct position measure the length from
the child's lower back to the back of their
knee.
Adjust the supports to the desired position
using the two knobs underneath the seat
base. To adjust, loosen the knobs, slide to
the desired position and retighten. Keep the
supports pointing straight forward at this
time unless wind sweeping or adduction,
abduction must be accommodated, in which
case set the angle accordingly using the
knobs again.
9.6 Adjusting the
femoral guides
To adjust the width of the femoral guides.
Loosen the screws (a) and position as
required. Retighten the screws. There are
two screws per femoral guide.
A