please contact your authorized LGB
retailer or Ernst Paul Lehmann
Patentwerk (see Authorized Service).
Notes for do-it-yourself assembly:
- Pull off the bridge from the decoder
interface.
- Plug the decoder onto the pins of
the PCB. The plug of the decoder
cable only fits the PCB pins when
aligned correctly.
- When a decoder is integrated in the
locomotive, the power control
switch (mode switch) is obsolete.
Notes for disassembly:
- If you wish to remove the decoder,
the bridge must be remounted onto
the DCC interface.
- Otherwise, the loco does not work.
SERVICE
Do-it-yourself service levels
- Beginner
- Intermediate
- Advanced
ATTENTION! Improper service will
void your warranty.
Note:
For quality service, contact your
authorized retailer or an LGB factory
service station (see Authorized
Lubrication
- The axle bearings and the side rod
bearings should be lubricated occa-
sionally with a small amount of
LGB Maintenance Oil.
Cleaning
- This model can be cleaned exter-
nally using a mild detergent and
gentle stream of water.
ATTENTION! Do not immerse this
model in the detergent.
ATTENTION! If the model is equipped
with a loudspeaker, it must not be
24
exposed to water directly.
Replacing the light bulbs
Front lights
:
- Pull the lantern housing away from
the model.
- Pull the bulb out of the socket.
- Plug in new bulb.
- Reassemble.
Rear lights
:
- Carefully pry the lens away from
the lantern.
- Using tweezers, remove the bulb.
- Plug in new bulb.
- Reassemble.
Cab light and drivetrain
illumination
:
- Using tweezers, remove the bulb.
- Plug in new bulb.
Replacing the traction tire
- Remove the screws on the side
rods and take the rods off the
wheels.
- Use a small, straight screwdriver to
replace the old traction tire:
- Pry the old traction tire out of
the wheel groove.
- Gently push the new traction tire 2
over the wheel and into the groove
of the traction wheel.
- Make sure that the traction tire is
seated properly in the wheel
groove.
- Reassemble.
: