Table of Contents
Advertisement
Superabrasive
STORAGE
Always store and transport the Lavina® X
machine in a dry place. Never transport
the Lavina® X machine unprotected; it may
be damaged if transported unprotected
during rain or snow.
When storing the machine the temperature may fall down to or to less than 32F (or 0
system using the following steps:
‐ Pull out the hose of the tank (Fig.3.9)
‐ Using compressed air blow out the water from the system for the two positions of the turn‐cock (Fig. 3.10, Fig. 3.11).
4. OPERATION
PRELIMINARY CONTROLS
Inspect the working area as explained in the safety instructions. For wet use, fill the water tank when the electrical cable is
disconnected. Connect the vacuum extractor and ensure that the vacuum hose is clear and that it will easily follow the machine. Plug
in the machine and make sure that the power cord is free to follow the direction of the working Lavina® X machine.
WATER FLOW CONTROL UNIT
Figure 4.1
Figure 4.2
ADJUSTING AND MOUNTING TOOLS
The Holder A41 in
LAVINA® X can work with either 3 or 6 buffers which will change its elasticity. You can make the change after
dismounting the holder as per the instruction in TROUBLESHOOTING.
In Lavina 25‐X the holder is initially mounted with 3 buffers.
Mount the tools only after ensuring that there is enough
diamond bond material left. Be sure that the plates are always
clean before mounting. WARNING: Always secure the
"QuickChange" pads with the security plate (Fig.4.4), lock with
the tool holder key (Fig.5.3). Diamond tools with Velcro are
attached to three 9inch foam plates (Fig.4.5). The foam plates are
mounted on the key lock (butterfly). Always use the tool holder
key (Fig.5.3).
User Manual
Figure 3.9
Figure 4.3
Original Language
Figure 3.10
o
The operator can choose the water sprayer in the front
when the tap is in the horizontal position (Fig.4.1), the
water will spray under the cover of the machine when
the level is in the vertical position (Fig.4.2).The flow
regulating valve located on the tank (Fig.4.3) is
increasing or reducing the water flow to the working
area – in front of the machine or under the main head
cover of the machine.
Figure 4.4
9
Lavina® 25‐X
Figure 3.11
C) you should empty the water from the
Figure 4.5
3/2015
Advertisement
Table of Contents
