Visual Indicators; Power Supply - Control Microsystems SCADAPack 32P Hardware Manual

Parity
Word Length
Stop Bits
Duplex (COM1,
COM2, COM 4)
Cable Length
Ethernet
Termination
Protocol
Protocol Modes
8.4

Visual Indicators

COM1,COM2,
COM4
Ethernet LAN
Push-button
8.5

Power Supply

Power Input
AC/DC PWR IN
DC power Input
DC PWR
5 Volt Power
Output
DC power
Output
16Vrms applied
Efficiency
Transient
Protection
SCADAPack 32P Controller Hardware Manual
May 26, 2006
none, even, or odd
7 or 8 bits
1 or 2 bits
full or half with RTS/CTS control
RS-232 –maximum 50 ft (15.2 m)
RS-485 –maximum 4000 ft (1200 m)
RJ-45 modular connector
10BaseT (twisted pair)
10M bits per second.
TeleBUS (compatible with Modbus RTU and Modbus ASCII)
slave, master, master/slave, store and forward
received data
transmitted data
clear to send
data carrier detect
Ethernet network receive or transmit data
Ethernet port connected to a network
I/O module LED power status LED
Status LED (shows functional status)
5V power LED (LED power not applicable)
Run LED
Forced I/O LED
Counter Inputs 0, 1, 2 and 3 LEDs
LED power toggle
16Vrms ±20%
13 to 24Vdc nominal
30Vdc maximum
30V maximum
10.7V typical turn on
9V typical turn off
5V at 1.3A capacity
5V at 500 mA required by SCADAPack 32P
20-24V with 1.0Vp-p maximum ripple.
300mA available at 5V/0.5A, de-rate linearly to 100mA
available at 5V/1.3A
80%, 12V on DC PWR input
Transient: 2.5kV surge withstand capability as per ANSI/IEEE
C37.90.1-1989
(RxD) LED
(TxD) LED
(CTS) LED
(DCD) LED
LAN LED
LINK LED
38