Supported Vlans - Cisco Catalyst 3560-X Software Configuration Manual

Understanding VLANs
Figure 1-1
Figure 1-1
VLANs 2
VLANs 8
VLANs are often associated with IP subnetworks. For example, all the end stations in a particular IP
subnet belong to the same VLAN. Interface VLAN membership on the switch is assigned manually on
an interface-by-interface basis. When you assign switch interfaces to VLANs by using this method, it is
known as interface-based, or static, VLAN membership.
Traffic between VLANs must be routed or fallback bridged. The switch can route traffic between
VLANs by using switch virtual interfaces (SVIs).
On switches running the LAN base feature set, static routing between VLANs is supported only on
Note
switches running Cisco IOS Release 12.2(58)SE or later.
An SVI must be explicitly configured and assigned an IP address to route traffic between VLANs. For
more information, see the
Interfaces" section on page
Note If you plan to configure many VLANs on the switch and to not enable routing, you can use the sdm
prefer vlan global configuration command to set the Switch Database Management (sdm) feature to the
VLAN template, which configures system resources to support the maximum number of unicast MAC
addresses. For more information on the SDM templates, see
or see the sdm prefer command in the command reference for this release.

Supported VLANs

The switch supports VLANs in VTP client, server, and transparent modes. VLANs are identified by a
number from 1 to 4094. VLAN IDs 1002 through 1005 are reserved for Token Ring and FDDI VLANs.
VTP version 1 and version 2 support only normal-range VLANs (VLAN IDs 1 to 1005). In these
versions, the switch must be in VTP transparent mode when you create VLAN IDs from 1006 to 4094.
VTP version 3 supports the entire VLAN range (VLANs 1 to 4094). Extended range VLANs (VLANs
1006 to 4094) are supported only in VTP version 3. You cannot convert from VTP version 3 to VTP
version 2 if extended VLANs are configured in the domain.
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-2
shows an example of VLANs segmented into logically defined networks.
VLANs as Logically Defined Networks
Switch A
Trunk port 1
– 4 (path cost 30)
– 10 (path cost 19)
Switch B
"Switch Virtual Interfaces" section on page 1-5
1-40.
Trunk port 2
VLANs 8 – 10 (path cost 30)
VLANs 2 – 4 (path cost 19)
Chapter 1, "Configuring SDM Templates,"
Chapter 1 Configuring VLANs
and the "Configuring Layer 3
OL-25303-03