Accessing The Cli Of A Specific Stack Member; Displaying Switch Stack Information - Cisco Catalyst 3560-X Software Configuration Manual

Accessing the CLI of a Specific Stack Member

Switch# show switch stack-upgrade status
Upgrade Time Remaining: 21 minutes
Unupgraded Stack:
Switch#
1
2
3
Upgraded Stack:
Switch#
Switch#
Accessing the CLI of a Specific Stack Member
Note This task is only for debugging purposes, and is only available from the master.
You can access all or specific members by using the remote command {all | stack-member-number}
privileged EXEC command. The stack member number range is 1 to 9.
You can access specific members by using the session stack-member-number privileged EXEC
command. The member number is appended to the system prompt. For example, the prompt for
member 2 is
session on the master. Only the show and debug commands are available on a specific member.

Displaying Switch Stack Information

To display saved configuration changes after resetting a specific member or the stack, use these
privileged EXEC commands:
Table 1-4
Command
show platform stack manager all
show platform stack ports {buffer |
history}
show switch
show switch stack-member-number
show switch detail
show switch neighbors
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
1-30
Status
Reload In Progress
RSU in Progress
RSU in Progress
Status
, and system prompt for the master is
Switch-2#
Commands for Displaying Stack Information
Switch#
Description
Display all stack information, such as the stack protocol
version.
Display the stack port events and history.
Display summary information about the stack, including the
status of provisioned switches and switches in
version-mismatch mode.
Display information about a specific member.
Display detailed information about the stack ring.
Display the stack neighbors.
Chapter 1 Managing Switch Stacks
. Enter exit to return to the CLI
OL-25303-03