Cisco Catalyst 3560-X Software Configuration Manual page 329

Chapter 1 Configuring IEEE 802.1x Port-Based Authentication
•
MAC Authentication Bypass
These are the MAC authentication bypass configuration guidelines:
•
•
•
•
Maximum Number of Allowed Devices Per Port
This is the maximum number of devices allowed on an 802.1x-enabled port:
•
•
•
Configuring 802.1x Readiness Check
The 802.1x readiness check monitors 802.1x activity on all the switch ports and displays information
about the devices connected to the ports that support 802.1x. You can use this feature to determine if the
devices connected to the switch ports are 802.1x-capable.
The 802.1x readiness check is allowed on all ports that can be configured for 802.1x. The readiness
check is not available on a port that is configured as dot1x force-unauthorized.
Follow these guidelines to enable the readiness check on the switch:
•
•
OL-25303-03
You can configure the inaccessible authentication bypass feature and the restricted VLAN on
–
an 802.1x port. If the switch tries to re-authenticate a critical port in a restricted VLAN and all
the RADIUS servers are unavailable, switch changes the port state to the critical authentication
state and remains in the restricted VLAN.
You can configure any VLAN except an RSPAN VLAN or a voice VLAN as an 802.1x restricted
VLAN. The restricted VLAN feature is not supported on internal VLANs (routed ports) or trunk
ports; it is supported only on access ports.
Unless otherwise stated, the MAC authentication bypass guidelines are the same as the 802.1x
authentication guidelines. For more information, see the
page 1-39.
If you disable MAC authentication bypass from a port after the port has been authorized with its
MAC address, the port state is not affected.
If the port is in the unauthorized state and the client MAC address is not the authentication-server
database, the port remains in the unauthorized state. However, if the client MAC address is added to
the database, the switch can use MAC authentication bypass to re-authorize the port.
If the port is in the authorized state, the port remains in this state until re-authorization occurs.
In single-host mode, only one device is allowed on the access VLAN. If the port is also configured with
a voice VLAN, an unlimited number of Cisco IP phones can send and receive traffic through the voice
VLAN.
In multidomain authentication (MDA) mode, one device is allowed for the access VLAN, and one
IP phone is allowed for the voice VLAN.
In multihost mode, only one 802.1x supplicant is allowed on the port, but an unlimited number of
non-802.1x hosts are allowed on the access VLAN. An unlimited number of devices are allowed on
the voice VLAN.
The readiness check is typically used before 802.1x is enabled on the switch.
If you use the dot1x test eapol-capable privileged EXEC command without specifying an interface,
all the ports on the switch stack are tested.
"802.1x Authentication" section on
Catalyst 3750-X and 3560-X Switch Software Configuration Guide
Configuring 802.1x Authentication
1-41