Ink Tank Latch/Ink Bay Inspection; Cutter Ispection - Printing Innovation iCUBE 1 User Manual

▪ moving parts (motor test)
▪ maintenance module sled assembly cleaning
▪ paper dust removal

▪ ink tank latch/ink bay inspection

▪ cutter inspection
Aerosol and debris removal; paper path optical sensor cleaning; wiper cleaning; waste ink
absorber inspection; ink tubing inspection; lift motor gear inspection; paper path grit roller
inspection – see at monthly maintenance tasks.
Moving Parts Motor Test
1. Activate the media path, cutter, pump, pinch valves, and maintenance module and
listen for any noises not present when the printer was new.
2. Inspect the motion of the media path and the maintenance module to ensure the
motion looks smooth and free.
Maintenance Module Cleanining
Clean the Maintenance Module (aka Service Station) every year.
1. Lay absorbent disposable towels under the base of the printer.
NOTE: it is recommended to do a system deprime before ejecting the maintenance
module. Also it is better to remove the printhead and cap it to avoid
contamination and adequate moisture.
2. In the Toolbox push 'Eject Service Station' button to send the maintenance module
to the eject position.
The maintenance module moves forward for easy access.
Picture of layed towels
-66-