Paper Cutting - Printing Innovation iCUBE 1 User Manual

tank, fitting, tubing, printhead or diaper. The likeliest cause is an over-full maintenance
module.
Solution
1. Remove the maintenance module and evaluate whether it was the cause.
2. Dismantle the printer to locate the source of ink.
Paper Cutting (PC)
Issues with paper cutting (PC) cause a range of defects, as detailed in the following
sections.
PC01: Cutter Not Operating
Cutter is not moving when commanded, thus stalling the print job and errors out.
Cause
This defect may also result when the cutter is not at home or has an obstruction.
Other causes include faulty sensor, wiring, PCA, driver, or motor. A common cause is that
the cutter connection is not plugged in, which may be difficult to see in an integrated
print engine.
Solution
Check that the cutter is connected. Try the "cutter home" command followed by a
"cutter cut" command. Use "cutter stats" command to determine the state of the
sensors.
PC02: Partial or Incomplete Cut
Cutter stops after a partial or incomplete cut. Home sensors will not be made and the
other 2 non home sensors will not be made.
Cause
Causes include obstruction, faulty sensor, wiring, PCA, driver or motor.
Solution
1. Try the "cutter home" command followed by a "cutter cut" command.
2. Use "cutter stats" command to determine the state of the sensors.
-136-