Table of Contents
Advertisement
Main menu
Position / Zoom (U)
Source (U)
Auto functions (U)
SMD 18101 CS / SMD 18101 CP / SMD 18101 D
Instruction Manual, 11/2005, A5E00472377A-002
Functions
H-position
V-position
Zoom (only with analog
mode and PIP "off")
BNC
DVI Digital
Video
S-Video
VGA
Auto brightness/contrast
Auto
position/phase/frequency
→ Execute selected
autofunctions
Adjustment/range
Slider from 0 ... 100
Slider from 0 ... 100
One to one
Fill screen
Fill to aspect ratio
Fill to square
Select source for main
display:
Select by pressing the Menu
key, and activate by pressing
the Up key.
On/off
On/off
Execute autofunctions
Commissioning
7.3 Description of OSD menu
Description /
The "Position / Zoom" menu
is used to change the size
and position of the picture on
the display
Shift picture in horizontal
direction
If the display and graphics
card resolutions are
identical, an optimum
adjustment is achieved
where the picture occupies
the complete area of the
display and is not offset by
even one single pixel.
Shift picture in vertical
direction
Selection between four
different picture size settings
The picture is displayed in
original size on the screen
The picture is displayed to fill
the complete screen
(1280 x 1024 pixels)
The picture is zoomed to the
maximum screen area with
retention of the aspect ratio.
The picture is zoomed to
square format
Use the "Source" menu to
select the picture source for
the display with full format
Following switching off and
on of the display, the last
picture source is displayed
again. It is irrelevant whether
the picture source was
selected using the OSD or
the Up/Down keys.
The autofunction is used to
assist the automatic setting
of parameters:
Frequency,
•
phase,
•
position,
•
brightness and
•
contrast.
•
The quality of the settings
depends on the picture
contents and the type of
synchronization.
All settings can of course
7-7
Advertisement
Table of Contents
