Section 9. Wiring Diagrams; Aqualink Rs Pool/Spa Combination And Pool/Spa Only - Jandy AquaLink RS6 Troubleshooting Manual

Section 9. Wiring Diagrams

9.1

AquaLink RS Pool/Spa Combination and Pool/Spa Only

RS Power Center Wiring Diagram for Pool and Spa and Only Models
S1 DIP SWITCH SETTINGS
Factory Setting
# OFF
1 Aux1
2 1 SPD Filter Pump
3 Aux 3
4 Cool Down
5 Normal
6 Spare Aux (Pool Mode)
7 See Manual
8 Gas Heater
S2 DIP SWITCH SETTINGS
Factory Setting
# OFF
1 Solar Heat Priority
2 Not Used
3 Not Used
4 Not Used
PDA Power Center Wiring Diagram
DIP SWITCH SETTINGS
Factory Setting
# OFF
1 Aux1
2 1 SPD Filter Pump
3 Aux 3
4 Cool Down
5 Normal
6 Spare Aux (Pool Mode)
7 See Manual
8 Gas Heater
IMPORTANT INSTALLATION INSTRUCTIONS:
Enclosure: Rainproof (Type 3R, IPX3) suitable for swimming pool/spa applications.
1. Installation must be by a qualified electrician and must comply with all national, state, and local codes.
2. Power Center must be mounted at least five (5) feet away from the inside edge of the pool.
Canadian installations must be at least three (3) meters from the water.
Les installation Canadiennes dolvent se trouver à au moins trois (3) mètres de l'eau.
3. Install to provide drainage of compartments for electrical components.
4. After wiring, install panels over wiring compartments and keep Power Center door closed.
5. For technical information, call Jandy Pool Products, Inc. at 707-776-8200 ext. 260.
Sheet #7192, Rev. H
CAUTION
Read Installation Manual completely
before installing. This product must
be wired in accordance with the
Installation Manual.
ATTENTION
Lire la notice technique.
Service Controller Connector
When Turned
ON
Cleaner
2 SPD Filter Pump
Spa Spillover
Disabled
See Manual
S1
Spare Aux (Spa Mode)
See Manual
Heat Pump
S2
When Turned
ON
Heat Pump Priority
Not Used
Not Used
Not Used
Relay Sockets (24 VDC output)
For Optional Multiplex PCB
Connect red four-pin connector
to Multiplex Board
(red terminal bar)
When Turned
ON
Cleaner
2 SPD Filter Pump
Spa Spillover
Disabled
See Manual
Spare Aux (Spa Mode)
See Manual
Relay Sockets (24 VDC output)
Heat Pump
F . Pump
WARNING
To reduce the risk of injury, do not permit
children to use this product unless they
are closely supervised at all times. Water
temperature in excess of 100°F/38°C
may be injurious to your health.
For Optional Multiplex PCB
Connect red four-pin connector
to Multiplex Board
4 3 2 1 4 3 2 1 6 5 4 3 2 1 10 9 8 7 6 5 4 3 2 1
To Controller To Remote
(red terminal bar) (brown terminal bar) (green terminal bar)
RS6 & RS8 ONLY
RESET
AUTO
SERVICE
TIME OUT
4 3 2 1 6 5 4 3 2 1 10 9 8 7 6 5 4 3 2 1
T o Controller T o Remote T o Sensors, etc.
(brown terminal bar)
(green terminal bar)
RS6 & RS8 ONLY
RESET
AUTO
SERVICE
TIME OUT
Relay Sockets (24 VDC output)
Aux. 1 Aux. 2 Aux. 3 Aux. 4
To Sensors, etc.
RS8 ONLY
POOL MODE
SPA MODE
SPA DRAIN
HEATER SOLAR
SPA FILL
JVA Sockets Relay Sockets
(24 VAC output) (24 VDC output)
Elect.
Heater
Solar
Return
JVA
JVA
Intake Cleaner Solar
JVA JVA Pump
JVA Sockets
Relay Sockets
(24 VAC output)
(24 VDC output)
RS8 ONLY
POOL MODE
SPA MODE
SPA DRAIN
HEATER SOLAR
SPA FILL
Aux. 5 Aux. 6 Aux. 7
Battery
(9Volt)
6000 Condor Drive • Moorpark, CA USA 930201
707.776.8200 • Fax 707.763.7785
Litho in USA © Jandy Pool Products, Inc. 0703
AVERTISSEMENT
Pour réduire le risque de blessures, ne
pas permettre aux enfants d'utiliser ce
produit à moins qu'ils soient supervisés
de près en tout temps. Des températures
de l'eau supérieures à 38°C/100°F peu-
vent présenter un danger pour la santé.
Page 41
Relay Socket
RELAY