Table of Contents
Advertisement
WKG Series Full Size Gas Convection Ovens - SERVICE PROCEDURES AND ADJUSTMENTS
3)
Exit the setup mode.
7.
Allow the oven to cycle at least two times
between adjustments.
A.
If the temperature variance still differs
more than 5°F from the set point, verify the
correct calibration offset value was entered
and retained.
1)
Adjust the calibration offset value as
outlined in step 6, until the cycling
temperature is within tolerance.
B.
If the above adjustment cannot be obtained,
replace the computer control and check for
proper operation.
F32700 Rev. B (0315)
Page 36 of 74
Advertisement
Table of Contents
