Roller Latch Assembly (Independent Doors); Door Catch Ball Assembly (Independent Doors); Door Window - Wolf WKG Series Service Manual

WKG Series Full Size Gas Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
Fig. 42
A. Door assembly parts are now accessible for
inspection and/or replacement if necessary.
6. Reverse procedure to re-assemble the door
assembly parts and check for proper adjustment
as outlined under DOOR CHAIN ADJUSTMENT
(SIMULATANEOUS DOORS).
ROLLER LATCH ASSEMBLY
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made after 8/12/07 and serial number starting with 54
made after 8/26/07.
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the screws that attach roller latch
assembly to door.
Fig. 43
Disconnect the
Page 19 of 74
2. Reverse procedure to install.
DOOR CATCH BALL ASSEMBLY
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made before 8/13/07 and serial number starting with
54 made before 8/27/07.
electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the TOP FRONT COVER.
2. Remove the screws that secure the door catch
assembly.
Fig. 44
3. Reverse procedure to install.
4. Adjust the ball catch as outlined under DOOR
CATCH BALL ADJUSTMENT (INDEPENDENT
DOORS).

DOOR WINDOW

electrical power to the machine and
follow lockout / tagout procedures.
1. Remove the screws at the top and bottom of
door.
Disconnect the
Disconnect the
F32700 Rev. B (0315)