Table of Contents
Advertisement
WKG Series Full Size Gas Convection Ovens - SERVICE PROCEDURES AND ADJUSTMENTS
4.
Move the door until proper alignment is achieved
then tighten the screws on the upper door
bearing hardware.
5.
Repeat STEP 3 and STEP 4 on the opposite
door, if necessary.
DOOR STRIKE ADJUSTMENT
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made after 8/12/07 and serial number starting with 54
made after 8/26/07.
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove TOP FRONT COVER.
2.
Open the doors and inspect door strike for proper
shape.
A.
Replace if bent. Do not bend strike plate.
B.
If adjustment is necessary, loosen
fasteners, close doors and insure contact
between door inner surface and upper
horizontal seal. Slide door strike plate until
contact with roller latch is made. Tighten
strike plate fasteners.
Fig. 66
3.
Open and close the doors several times while
observing the roller latch and strike plate
operation.
A.
Replace roller latch if malfunctioning as
outlined under ROLLER LATCH
ASSEMBLY (INDEPENDENT DOORS)
and adjust as outlined in this procedure.
F32700 Rev. B (0315)
Disconnect the
Page 32 of 74
4.
Each oven door should open with a force of 8 to
25 pounds when pulled at the handle. The
adjustments must allow the doors to remain
closed during normal operation and allow
opening without exertion by the user.
DOOR CATCH BALL ADJUSTMENT
(INDEPENDENT DOORS)
NOTE: For units with serial number starting with 48
made before 8/13/07 and serial number starting with
54 made before 8/27/07.
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove TOP FRONT COVER.
2.
Open the doors and inspect door strike for proper
shape.
Fig. 67
A.
Replace if bent and adjust as outlined in this
procedure.
3.
Open and close the doors several times while
observing the catch ball operation.
A.
Replace if malfunctioning and adjust as
outlined in this procedure.
NOTE: Shims may be required under the door strike,
before the proper door tension adjustment can be set.
Disconnect the
Advertisement
Table of Contents
