Table of Contents
Advertisement
WKG Series Full Size Gas Convection Ovens - REMOVAL AND REPLACEMENT OF PARTS
Fig. 38
C.
If replacing the bottom bearing, remove it
from the door shaft or the lower sill opening.
8.
Reverse procedure to install door assembly and
check for proper adjustment as outlined under
DOOR ADJUSTMENT and DOOR SWITCH
ADJUSTMENT.
OVEN DOORS (SIMULTANEOUS
DOORS)
electrical power to the machine and
follow lockout / tagout procedures.
Assembly Removal
1.
Remove the TOP FRONT COVER and BOTTOM
FRONT COVER.
2.
Remove the door switch lever.
Fig. 39
3.
Remove the top bearing retainers and top
bearings.
F32700 Rev. B (0315)
Disconnect the
Page 18 of 74
Fig. 40
4.
Remove the lower door seal strip to expose the
mounting screws of the door assembly.
A.
Remove the two (2) lower sill bolts by the
lower door shaft and the four (4) counter-
sunk screws from the lower sill.
Fig. 41
NOTE: The door assembly is heavy and will drop
down once the last screw is removed. If removing door
assembly with-out assistance, use caution.
5.
Lift up on the door assembly and swing the right
side out then move the assembly to the left to
clear the slots in the upper door sill.
6.
Lay the door assembly on a flat cushioned
surface for disassembly.
7.
Reverse procedure to install door assembly and
check for proper adjustment as outlined under
DOOR ADJUSTMENT, DOOR CHAIN
ADJUSTMENT (SIMULTANEOUS DOORS) and
DOOR SWITCH ADJUSTMENT.
Disassembly
1.
Remove the door assembly as outlined in
ASSEMBLY REMOVAL.
2.
Remove the door chain by loosening one of the
turnbuckles.
3.
Loosen the set screw on the sprocket of door
being replaced.
4.
Drive out the Spirol pin from the sprocket of door
being replaced.
5.
Remove the door from lower sill bearings and
sprocket.
Advertisement
Table of Contents
