Table of Contents
Advertisement
WKG Series Full Size Gas Convection Ovens - SERVICE PROCEDURES AND ADJUSTMENTS
not occur even though the sparking circuit is
functioning properly.
Fig. 61
4.
Plug the oven in and set the temperature control
to the maximum setting.
5.
Turn the power switch ON.
6.
Sparking should occur after a 4 second delay, for
a duration of 7 seconds then repeat twice after a
15 second purge time. Arching from the ignition
cable to the oven frame should be observed.
DOOR SWITCH ADJUSTMENT
electrical power to the machine and
follow lockout / tagout procedures.
1.
Remove the TOP FRONT COVER.
2.
Door operation:
A.
Independent doors - The switch actuator
should be operated by the switch lever when
the right door is between 1" and 1 ½" from
being closed.
B.
Simultaneous doors - The switch actuator
should be operated by the switch lever when
the right door is ½" from being closed.
3.
If adjustment is necessary, bend the switch
actuator to obtain the proper setting.
F32700 Rev. B (0315)
Disconnect the
Page 30 of 74
Fig. 62
4.
Install the top front cover
5.
Apply power to the oven and check for proper
operation.
BLOWER ADJUSTMENT
electrical power to the machine and
follow lockout / tagout procedures.
SHUT OFF THE GAS BEFORE
SERVICING THE UNIT.
1.
Remove the blower motor and mounting
assembly by following steps 1 through 8 as
outlined under BLOWER AND MOTOR.
2.
Loosen the motor mounting bolts.
3.
Adjust the motor position until the blower is
parallel to and 1/4 inch away from the motor
mounting plate. Check for squareness of the
blower to the motor mounting plate at the top,
bottom, left and right of the blower.
A.
If the blower is square then tighten motor
mounting bolts and proceed to STEP 4.
B.
If the blower is not square continue
adjusting until proper spacing is achieved
then tighten motor mounting bolts.
NOTE: If necessary, place shims between motor and
frame.
Disconnect the
Advertisement
Table of Contents
