Information On The Display Panel - Bosch WAT SERIES Instruction Manual And Installation Instructions

Faults and what to do about them.
en

Information on the display panel

Display
è lights up
è flashes
r lights up
E
Å lights up
: the "Ready in" time
flashes
.the "Ready in" time
flashes
E:18
E:23
E:32
E:93
Other displays
24
Cause/remedy
The temperature is too high. Wait until the temperature drops.
■
The water level is too high. It is not possible to add laundry. Close the door
■
immediately, if necessary. Press the A button to continue the programme.
Laundry may be caught. Open and close the door again and press the A but-
■
ton.
If necessary, push the door closed or remove some laundry and then push it
■
closed again.
If necessary, switch the appliance off and on again; set the programme and
■
make your individual settings; start the programme.
Turn on the cold water tap fully,
■
Supply hose kinked/trapped,
■
The water pressure is too low. Clean the filter. ~ Page 22
■
The childproof lock is activated – deactivate it.
Too much foam has been detected and an additional wash cycle has been acti-
vated. Add less detergent to the next washing cycle with the same load.
~ Page 17
Mains voltage is too low.
Undervoltage in the wash programme.
The programme duration is extended. ~ Page 19
The drain pump is blocked. Clean the drain pump. ~ Page 21
■
The drain hose/drain pipe is blocked. Clean the drain hose at the siphon.
■
~ Page 22
There is water in the base trough; the appliance is leaking. Turn off the tap. Call the
after-sales service.
flashes alternately with End at the end of the programme.
Not a fault – the unbalanced load detection system has interrupted the spin cycle
because the laundry is unevenly distributed.
Distribute small and large items of washing in the drum. If required, spin the laundry
once more.
Turn on the hot water tap fully,
■
The supply hose for hot water is kinked/trapped,
■
The hot water pressure is too low. Clean the filter ~ Page 22,
■
The supply hose for hot water is not connected correctly. Connect both supply
■
hoses (hot and cold water) for hot water appliances. ~ Page 31
Note: Ignore the message; it is only displayed for the first wash cycle.
Switch off the appliance, wait for five seconds and then switch it on again. If the dis-
play appears again, call the after-sales service. ~ Page 27