Bosch WAT SERIES Instruction Manual And Installation Instructions page 31

Observe the following when connecting
the machine:
Notes
With a cold water connection, only
■
operate the washing machine using
cold mains water.
With a hot water connection, operate
■
the washing machine with hot and
cold mains water, with a maximum
temperature of 60 °C.
Do not connect the machine to the
■
mixer tap of an unpressurised hot-
water boiler.
Do not use a used supply hose. Only
■
use the supply hose supplied or one
that was purchased from an
authorised specialist retailer.
Do not bend, squash, modify or cut
■
through the water supply hose
(otherwise its strength is no longer
guaranteed).
Only tighten the screw fitting by
■
hand. If the screw connections are
tightened too much with a tool
(pliers), the thread may get
damaged.
Optimum water pressure in the supply
network
At least 100 kPa (1 bar)
Maximum 1000 kPa (10 bar)
When the tap is open, the water flow
rate is at least 8 l/min.
If the water pressure is higher than this,
a pressure-reducing valve must be
installed.
Cold water connection
With a cold water connection, only
Note:
operate the washing machine using cold
mains water.
Connect the water supply hose to the tap
(26.4 mm = ¾") and to the appliance (not
necessary for Aqua-Stop models as this is
permanently installed):
Model: Standard
■
Positioning and connecting
Model: Aqua-Secure
■
Model: Aqua-Stop
■
Note: Turn on the tap carefully, checking
the leak tightness of the connection
points. The screw connection is under
mains water pressure.
Hot and cold water connection
Notes
With a hot water connection, operate
■
the washing machine with hot and cold
mains water, with a maximum
temperature of 60 °C.
Red hot water supply hose on the hot
■
water tap and red valve on the
appliance
White cold water supply hose on the
■
cold water tap and white valve on the
appliance
en
31