The Drain Hose At The Siphon Is Blocked; Filter In The Water Supply Blocked - Bosch WAT SERIES Instruction Manual And Installation Instructions

Cleaning and maintenance
en
Take the drain hose out of the
4.
retainer.
Remove the sealing cap, allow the
detergent solution to flow out into a
suitable container.
Replace the sealing cap and place
the drainage hose in the retainer.
Carefully unscrew the pump cover,
5.
residual water may leak out.
Clean the interior, pump cover
thread and pump housing. The
impeller in the detergent solution
pump must be able to rotate.
Refit the pump cover and screw it on
tightly. The handle must be in a
vertical position.
Place the service flap back on, lock
6.
it into place, and close it.
To prevent unused detergent
Note:
from flowing straight into the drain
during the next wash: Pour 1 litre of
water into compartment II and start the
[ Empty programme.
22
The drain hose at the siphon
is blocked
Switch off the appliance. Disconnect
1.
the mains plug.
Loosen the hose clamp. Carefully
2.
remove the drain hose, residual
water may leak out.
Clean the drainage hose and siphon
3.
connecting piece.
Reattach the drainage hose and
4.
secure the connection using the
hose clamp.
Filter in the water supply
blocked
First, reduce the water pressure in the
supply hose:
Turn off the tap.
1.
Select any program (except Rinse//
2.
Spin/Empty).
Press the A button.Allow the
3.
program to run for approximately 40
seconds.
Turn the program selector to Off.
4.
Pull out the mains plug.
Clean the filter on the tap:
5.
Disconnect the hose from the tap.
Clean the filter with a small brush.
For standard and Aqua-Secure
6.
models, clean the filter on the rear of
the appliance: