Childlock; Adding Laundry; Changing The Programme; Cancel The Programme - Bosch WAT SERIES Instruction Manual And Installation Instructions

Operating the appliance
en

Childlock

(E 3 sec., E 3 δευτ.)
You can lock the washing machine to
prevent the functions you have set from
being changed inadvertently. To do this,
activate the childproof lock when the
program has started.
To activate/deactivate, press and hold
theSpin speed and Finished in-time
buttons at the same time for approx.
three seconds.The E symbol appears in
the display panel.
E lights up: The childproof lock is
■
active.
E flashes: The childproof lock is
■
active and the program selector has
been adjusted.To deactivate the
childproof lock, reset the program
selector to the initial program. The
symbol lights up again.
To avoid the program to
Note:
terminate, do not turn the program
selector beyond the Off position.
The childproof lock remains
Note:
active after the program has ended and
the appliance is switched off. You must
always deactivate the childproof lock if
you want to start a new program.

Adding laundry

Following the start of the program, you
can add or remove laundry as required.
Press the A button to do this.
The A button indicator lamp flashes
and the machine checks whether it is
possible to add laundry.
If the following appears in the display
panel:
the è symbol disappears, and
■
adding is possible.
the è symbol lights up, it is not
■
possible to add laundry.
18
To continue the program, press the
button A.The program continues
automatically.
Notes
Do not leave the door open for too
■
long when adding laundry as water
from the laundry may leak out.
For safety reasons, the door remains
■
locked when the water level or
temperature is high, or while the
drum is turning, and it is not possible
to add laundry during this time.
The load display is not active during
■
reloading.

Changing the programme

Press the A button.
1.
Select another program.
2.
Press the A button.The new
3.
program starts from the beginning.

Cancel the programme

For programs at high temperature:
Press the A button.
1.
To cool down laundry: Select '
2.
Rinse.
Press the A button.
3.
For programs at low temperature:
Press the A button.
1.
Select 0 Spin/Drain//Spin/Empty
2.
[.
Press the A button.
3.
Programme end during rinse
hold
- - - - 0 appears in the display panel and
the indicator lamp of the A button
flashes.
Continue the program by:
Pressing the A button or
■