Programme End; Removing Laundry/Switching Off The Appliance; Sensors; Automatic Load Sensing - Bosch WAT SERIES Instruction Manual And Installation Instructions

Selecting a spin speed or setting the
■
program selector to 0 Spin/Drain//
Spin/Empty [ and then pressing
the A button.

Programme end

End appears in the display panel and
the indicator lamp of the A button is
off.
Removing laundry/switching
off the appliance
Open the door and remove the
1.
laundry.
Turn the program selector to Off .
2.
The appliance is switched off.
Turn off the tap.
3.
Not required for Aqua-Stop
Note:
models.
Notes
Do not leave any items of laundry in
■
the drum.They may shrink in the next
wash or discolour another item.
Remove any foreign objects from the
■
drum and the rubber seal – risk of
rusting.
Wipe the rubber seal dry.
■
Leave the door and detergent
■
drawer open so that any residual
water can evaporate.
Always wait until the program ends,
■
as the appliance could still be
locked. Then switch the appliance
on and wait for it to unlock.
If the display panel goes off at the
■
end of a program, the energy-saving
mode is active.Press any button to
activate the panel.
H

Sensors

A utomatic load sensing
S e n s o r s
The automatic load sensing function
adapts the water consumption ideally to
each programme depending on the
type of fabric and the load.
Unbalanced load detection
system
The automatic unbalanced load
detection system detects imbalances
and ensures even distribution of the
laundry by repeatedly starting and
stopping drum spinning.
If the laundry is extremely unevenly
distributed, the speed is reduced or the
spin cycle is not performed for safety
reasons.
Place large and small items of
Note:
laundry evenly in the drum. ~ Page 25

VoltCheck

depending on the model
The automatic voltage control system
detects an unauthorised voltage under-
usage. The colon on the Ready in
display is flashing. ~ Page 10
Once the supply voltage is stable again,
the colon of the Ready in display lights
up (Normal mode).
The detected voltage under-usage is
indicated in the further program
sequence by all three points lighting up
in the display.
Voltage under-usages can for
Note:
example result in program extensions
and/or a non-satisfactory spin result.
Sensors
en
19