Machine Housing/Control Panel; Drum; Descaling; Detergent Drawer And Housing - Bosch WAT SERIES Instruction Manual And Installation Instructions

Machine housing/control
panel
Wipe the housing and the control
■
panel with a soft, damp cloth.
Remove the detergent residue
■
immediately.
Do not clean with a water jet.
■

Drum

Use chlorine-free cleaning agents, do
not use steel wool.
If there are odours in the washing
machine, or to clean the drum, run the
¾ Drum Clean 90 °C or i
Cottons 90 °C program without
laundry. Add washing powder.

Descaling

Descaling should not be necessary if
the detergent is measured out correctly.
However, if it is required, follow the
manufacturer's instructions for the
descaling agent. Suitable descalers can
be obtained via our website or from our
after-sales service.

Detergent drawer and housing

If the washing machine contains
detergent or fabric softener residues:
Pull out the detergent drawer. Press
1.
down the insert and fully remove the
drawer.
To remove the insert: Push the insert
2.
upwards from below with your finger.
Cleaning and maintenance
Clean the detergent dispenser tray
3.
and insert with water and a brush,
and dry it. Clean the inside of the
housing as well.
Fit the insert and lock it in place
4.
(push the cylinder onto the guide
pin).
Push in the detergent drawer.
5.
Leave the detergent drawer open
Note:
so that any residual water can
evaporate.
Detergent solution pump
blocked
:
Warning
Risk of scalding!
When you wash at high temperatures,
the water gets very hot. If you come into
contact with the hot water, you may be
scalded.
Allow the water to cool down.
Turn off the water tap so that no
1.
more water can flow in and has to be
drained via the drain pump.
Switch off the appliance. Disconnect
2.
the mains plug.
Open and remove the service flap.
3.
en
21