How To Assembly
To use the extension tubes with the floor brush, push one of the extension tubes into the
suction hole, then insert the other extension tubes into each other and then insert the floor
brush into the last extension tube. The crevice tool can also be used with the extension
tubes.
USING THE PRODUCT
1. Push the power switch forward to turn on.
2. Pull the power switch back to turn off.
MAINTENANCE
The instructions given in this booklet serve as a guide to routine maintenance. Keep the
cleaner operating at top efficiency. Empty the dust cup and clean the filter after each use.
Empty Dust Cup
1. Push down on dust cup latch.
2. Pull dust cup from handle section.
3. Remove motor filter from dust cup.
4. Shake contents into a waste container.
5. Clean motor filter (refer to CLEANING)
6. Replace motor filter in the dust cup
7. Press dust cup onto handle section until they snap together.
CLEANING
Clean the motor filter after each cleaner use.
1. Remove the filter frame from the dust cup.
2. Shake and brush the dust and dirt from filter
3. If desired, remove filter from filter frame and launder the filter by hand in warm water (150°F,
65°C) using a mild detergent.
4. Air dry thoroughly.
5. Replace filter over frame.
Dispatch:
Carry the appliance in the original package
or a similar, well-padded package to prevent
damage to the appliance.
Off
On
10
Need help?
Do you have a question about the RC1200 and is the answer not in the manual?