Error Codes - Paxar TC6032EM Equipment Manual

Problem
The display does not turn on.
An error code and
corresponding message
appears on the display.

Error Codes

Following are some common error codes you may receive.
Code(s) Description
004 – 005 Supply size is incorrect. Reload the correct supplies.
267 – 271 Communication error. See your System Administrator.
410 – 413
Supply Error. Load supplies or make sure they are loaded
703 – 704
correctly.
750 Printhead is overheated. Turn off the printer to let it cool.
751 – 753 The printer sensed a problem with a mark on the supplies.
Check the supplies to see if they are loaded correctly.
756 The printer is out of supplies. Load supplies.
757 Load supplies. The calibrated supply length differs by plus
or minus .25 inches from the format.
758 Supply error. Check for a label jam. Clear the supply path
or reload supplies.
762 Low battery. Recharge the battery.
763 Waiting to dispense label. Press Enter.
768 Printhead error. See your System Administrator.
790 – 791 The printer is busy or has an error pending. Turn off the
printer. Wait two seconds and turn it back on.
904 – 911 System error. See your System Administrator.
SYSTEM System error. See your System Administrator.
ERROR
VECTOR ##
If these solutions do not work or you have a problem or error code not listed,
see your System Administrator or call Service at the number listed on the
back of this manual
6-2 Equipment Manual
Solution
Make sure the power is on.
Switch to a fully-charged battery.
See your System Administrator.