Anti-Tilt Bracket - DeLonghi DEFV908R Use And Care Instructions Manual

ANTI-TILT BRACKET

Important!
To restrain the appliance and prevent it
tipping accidentally, fit a bracket to its
rear to fix it securely to the wall. Make
sure you also fit the supplied lock pin to
the anti-tilt bracket.
To fit the anti-tilt bracket:
1. After you have located where the
cooker is to be positioned, mark on the
wall the place where the two screws
of the anti-tilt bracket have to be fitted.

Please follow the indications given in
fig. 8.
2. Drill two 8 mm diameter holes in
the wall and insert the plastic plugs
supplied.

Important!

Before drilling the holes, check that
you will not damage any pipes or
electrical wires.
3. Loosely attach the anti-tilt bracket with
the two screws supplied.
4. Move the cooker to the wall and adjust
the height of the anti-tilt bracket so
that it can engage in the slot on the
cooker's back, as shown in fig. 8.
5. Tighten the screws attaching the anti-
tilt bracket.
6. Push the cooker against the wall so
that the anti-tilt bracket is fully inserted
in the slot on the cooker's back.
7. Access the bracket and fit the lock pin:
■ Open the pivoting panel (fig. 9).
■ Fit the lock pin through the bracket, as
shown (fig. 10).
■ Close the pivoting panel.
12
Figure 8
0
+ 25
0
+ 25
0
Figure 9
+ 25
Figure 10
1
1
Lock pin
Lock pin
Slot on the
cooker's back
Slot on the
2
cooker's back
2
Lock pin
Lock pin correctly
correctly
tted
tted
Pivoting
panel
Pivoting
panel
Anti-tilt bracket
attached on the
rear wall
Anti-tilt bracket
attached on the
Cooker' s
rear wall
back
Cooker' s
back