Anti-Tilt Bracket - DeLonghi DE 60 GW Installation And Service Instructions Use And Care Instructions

ANTI-TILT BRACKET

Important!
To restrain the appliance and pre-
vent it tipping accidentally, fit a
bracket to its rear to fix it securely
to the wall. Make sure you also fit
the supplied lock pin to the anti-tilt
bracket.
To fit the anti-tilt bracket:
1. After you have located where the
cooker is to be positioned, mark on
the wall the place where the two
screws of the anti-tilt bracket have to
be fitted. Please follow the indica-
tions given in Fig.5a.
2. Drill two 8 mm diameter holes in the
wall and insert the plastic plugs sup-
plied.
Important!
Before drilling the holes, check that you will
not damage any pipes or electrical wires.
3. Loosely attach the anti-tilt bracket with the two
screws supplied.
4. Move the cooker to the wall and adjust the
height of the anti-tilt bracket so that it can
engage in the slot on the cooker's back, as
shown in Fig. 5a.
5. Tighten the screws attaching the anti-tilt bracket.
6. Push the cooker against the wall so that the anti-
tilt bracket is fully inserted in the slot on the cook-
er's back.
7. Access the bracket and fit the lock pin:
• Remove the drawer (Fig. 5b).
• Fit the lock pin through the bracket, as shown
(Fig. 5c).
• Refit the drawer.
1
Lock pin
Slot on the
cooker's back
8
0
+15
Anti-tilt bracket
attached on the
rear wall
Cooker's
back
Dotted line showing the position of
the cooker when installed
min 95 - max 110
(depending on feet
height adjustment)
Figure 5a
Fitting the anti-tilt bracket
Figure 5b
2
Lock pin
correctly
fitted
Figure 5c
Fitting the lock pin through
the bracket
=
=
5 7
1
4
Removing the drawer