DeLonghi DEFV908R Use And Care Instructions Manual page 25

LIGHTING GAS BURNERS FITTED
WITH FLAME FAILURE SAFETY
DEVICE AND
IGNITION (Auxiliary, Semi-rapid and
Rapid burners)
1. Check that the electricity is switched
on to allow spark ignition.
2. The gas flow to the burner is controlled
by taps with safety cut-out device.

If the burner flame should go out, the
safety cut-off valve will automatically
stop the gas flow.

The switch for the electric ignition is
incorporated in the knobs.
3. To ignite automatically, push the
required knob down and turn it to the
maximum position "
25, keeping the knob down until the
burner lights.

When the flame is lit, wait for about ten
seconds with the knob down (safety
cut-off activation delay).
4. Whenever the lighting of the burners
is difficult due to peculiar conditions of
the gas features or supply, it is advised
to repeat the ignition with the knob on
minimum position.
5. If when lighting any of the burners
an abnormal flame appears, switch
the burner off and relight using the
minimum setting.
6. If the flame is still not correct, turn
the burner off and call our Customer
Service center
Authorized Delonghi Service Agent.
7. In the case of a mains failure light the
burner with a match or lighted taper.
8. Adjust the gas valve to the desired
position.
If the burner flames should go out for
some reason, the safety valve will
automatically stop the gas flow.
To re-light the burner, return the knob to
the closed (off) position, wait for at least
1 minute and then repeat the lighting
procedure.
ELECTRONIC
" (figs. 24,
for your nearest
Figure 24
Figure 25
25