DeLonghi DEFV908R Use And Care Instructions Manual page 27

LIGHTING GAS BURNERS FITTED
WITH FLAME FAILURE SAFETY
DEVICE AND
IGNITION
(Dual burner)
1. Check that the electricity is switched
on to allow spark ignition.
2. The gas flow to the burner is controlled
by a tap with safety cut-out device.

If the burner flame should go out, the
safety cut-off valve will automatically
stop the gas flow.

The switch for the electric ignition is
incorporated in the knob.
3. To ignite automatically, push and
turn the knob in an clockwise or
anticlockwise direction up to the
position (maximum rate of inner
crown) or
rate of inner+outer crown), keeping the
knob down until the burner lights (figs.
26, 27, 28).

When the flame is lit, wait for about ten
seconds with the knob down (safety
cut-off activation delay).
4. Whenever the lighting of the burner is
difficult due to peculiar conditions of
the gas features or supply, it is advised
to repeat the ignition with the knob on
minimum position.
5. If when lighting any of the burners
an abnormal flame appears, switch
the burner off and relight using the
minimum setting.
6. If the flame is still not correct, turn
the burner off and call our Customer
Service center
Authorized Delonghi Service Agent.
7. In the case of a mains failure light the
burner with a match or lighted taper.
8. Adjust the gas valve to the desired
position.
If the burner flames should go out for some reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to the closed (off) position, wait for at least 1
minute and then repeat the lighting procedure.
ELECTRONIC
position (maximum
for your nearest
Figure 26
Figure 27
Figure 28
27