Information Display - Yamaha SHVO Owner's Manual

To switch to the tachometer from the speed-
ometer:
Push the "SPEED/RPM" button for at least 1
second after the multifunction information
center is activated. When the meter switches
to the analog tachometer function, the
"RPM" indicator light comes on.
1
1 "SPEED/RPM" button
2 "RPM" indicator light
Analog speedometer
The analog speedometer shows the water-
craft speed against water.
The small inner numbers on the meter show
the watercraft speed in kilometers per hour
"km/h" and the large outer numbers show the
speed in miles per hour "mph".
The "SPEED" indicator light comes on when
the analog speedometer is selected.
To switch to the speedometer from the ta-
chometer:
Push the "SPEED/RPM" button for at least 1
second after the multifunction information
center is activated. When the meter switches
to the analog speedometer function, the
"SPEED" indicator light comes on if "km/h"
are selected as the display units. The
"SPEED" indicator light blinks three times,
then comes on, if "mph" are selected as the
display units. (See page 41 for information on
Instrument operation
switching the digital speedometer display
units.)
1
1 "SPEED/RPM" button
2 "SPEED" indicator light
EJU35025

Information display

2
The information display shows watercraft op-
erating conditions.
1
1 Fuel level meter
2 Fuel indicator
3 Hour meter/voltmeter
4 Digital speedometer
5 Engine overheat warning indicator
6 Check engine warning indicator
7 Oil pressure warning indicator
EJU42361
Digital speedometer
The digital speedometer shows the water-
craft speed against water.
By switching the display units, the speed can
be shown in kilometers per hour (km/h) or
miles per hour (mph).
2 3 4
5 6 7
2
41