John Lewis JLWD 1612 User Manual page 41

Problem
The appliance does not fill with
water and drain immediately.
The appliance does not drain
the water.
The spin phase does not oper-
ate or the washing cycle lasts
longer than usually.
There is water on the floor.
You cannot open the appliance
door.
The appliance makes an unusu-
al noise.
The cycle is shorter than the
time displayed.
Washer Dryer User Manual
Possible solution
Make sure that the drain hose is in the correct position. The hose may be too
low.
Make sure that the sink spigot is not clogged.
Make sure that the drain hose has no kinks or bends.
Make sure that the drain filter is not clogged. Clean the filter, if necessary. Re-
fer to 'Care and cleaning'.
Make sure that the connection of the drain hose is correct.
Set the drain programme if you set a programme without drain phase.
Set the drain programme if you set an option which ends with water in the
tub.
Set the spin programme.
Make sure that the drain filter is not clogged. Clean the filter, if necessary. Re-
fer to 'Care and cleaning'.
Adjust manually the items in the tub and start the spin phase again. This prob-
lem may be caused by balance problems.
Make sure that the couplings of the water hoses are tight and there is not wa-
ter leakages.
Make sure that the drain hose have no damages.
Make sure you use the correct detergent and the correct quantity of it.
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the drum.
Make sure the levelling of the appliance is correct. Refer to 'Installation'.
Make sure that the packaging and/or the transit bolts are removed. Refer to
'Installation'.
Add more laundry in the drum. The load may be too small.
The appliance calculates a new time according to the laundry load. See the
'Consumption Values' chapter.
41