Table of Contents
Advertisement
C h e c k i n g S u p p l y Q u a l i t y
The printer continuously stores data from the most recent 16
supplies printed to check the reflectivity of the sensor marks on
the supply. Before you check your supply quality, print a batch of
supplies or test labels.
1. From the Diagnostics menu, press
2. Press
Press
or
3. Press
"No data! Press Enter" appears. You will also see the "No
data! Press Enter" message if you are using continuous
(non-indexed) supplies.
If you have printed labels since turning on the printer, you will
see
The Len listing is the length of the loaded supply in dots.
The Max listing should always be greater than the Min listing.
However, if you have used a Monarch® 9446
Monarch® 9
Max listing. The OK listing tells whether the sense mark on the
supply passed a detection test. Press
readings. If you are not using a Version 5.2 hardware (sensing
system) and you try to check the supply quality, the message "HW
not supported" appears.
DIAGNOSTICS
User Diag
. You will be at the User Diagnostics menu.
until you see
USER DIAG
Supply Quality
. If you have not printed any labels, the message
Len
Min
1568 034 124 Y
printer, the Min listing can be greater than the
or
until you see
Max OK
printer or a
to see the other
Diagnostics 8-3
Advertisement
Table of Contents
