Table of Contents
Advertisement
4. Press
C u t P o s i t i o n
This function adjusts where the tag is cut. The printer adjusts the
cut position according to the black marks on the supply. You may
need to adjust for aperature supplies. Increase to move the cut
up; decrease to move the cut down.
To change the setting, from the Main Menu, select Setup, then
Supply.
1. Press
2. Press
3. Press
decreases the value (moves the cut down);
(moves the cut up).
4. Press
2-8 Setting Supply Options
when the number you need appears. Press
twice to exit to the Main menu.
Then, follow these steps.
or
until you see
. You will see the current setting, for example:
Enter knife adj
[-300/300]: +0
or
to change the cut position. Pressing
when the number you need appears. Press
to exit to the Setup menu.
SUPPLY
Cut Pos
increases it
Advertisement
Table of Contents
