Table of Contents
Advertisement
1- 20
FEATURES OF YOUR HYUNDAI
SB090P1-E
SEAT BELTS (3-Point Type)
To Fasten The Seat Belt
The seat belts are fastened by pulling
the belt buckle towards the seat belt
stalk and inserting the metal tongue of
the buckle into the stalk. The buckle
should be firmly pressed into the stalk
until locked which will be indicated by
an audible "click".
The length of the seat belt webbing will
be automatically adjusted by the seat
belt mechanism to allow the wearer
maximum freedom of movement whilst
the belt is being worn. However, in the
event of rapid deceleration or impact,
the belt mechanism will automatically
lock.
tbuk-1a.p65
20
The mechanism will also lock if the seat
belt webbing is withdrawn too quickly
when the belt is being fastened or if
attempts are made to withdraw the
webbing whilst the vehicle is not on
level ground. Should the seat belt lock
under these conditions, it will be pos-
sible to release the mechanism by al-
lowing a small amount of webbing to be
retracted and the belt withdrawn again.
B200A01S-GAT
Adjusting Your Seat Belt
B180A01L-D
You should place the belt as low as
possible on your hips, not on your
waist. If the belt is located too high on
your body, you could slide under it in
case of accident or a sudden stop.
This could result of death, serious
injury or property damage. Both arms
should not be under or over the belt.
Rather, one should be over and the
other under, as shown in the illustration.
Never wear the seat belt under the arm
nearest the door.
B200A01L-D
3/23/04, 2:21 PM
Advertisement
Chapters
Table of Contents
