Changing Modes - Num'axes iki sonic User Manual

Changing modes

In the factory, the collar's mode is positioned on mode 3 (ultrasounds + vibrations).
To change the collar's mode, when switching on the collar you need to approach and keep the
magnetic key in contact with the orange mark.
A series of beep sounds is emitted (from 1 to 3 beeps) indicating the selected mode.
Keep the magnetic key in contact with the orange mark to run through modes.
Remove the magnetic key when you have reached the mode you wish.
The collar will memorize your selected mode.
Next time you will switch on the collar, your collar will be turned on to the last mode you
previously selected.
The chart below indicates how your collar operates according to the mode you have selected:
Number of beep sounds heard when
switching modes
Setting the barking detection sensitivity
Setting the barking detection sensitivity is a very important preliminary operation. In fact, this
setting determines the correct operation of the product.
It ensures detection of any barking but helps avoid unnecessary detection.
The detection, must therefore be sufficiently sensitive but not overly sensitive. In factory, barking
detection sensitivity is set on the maximum position (maximum sensitivity).
To adapt the detection sensitivity to the barking strength of your dog, you should proceed as
follows:
- Remove the 2 screws from the battery cover with a screwdriver.
- Remove the battery cover.
- Carefully turn the setting screw according to the sensitivity you wish (See. Diagram 5)
Caution: the adjustment system has a stop for the minimum sensitivity and a stop for the
maximum sensitivity. Turn delicately and without forcing with the supplied screwdriver.
1
2
3
Mode
1 ultrasounds only
2 vibrations only
3 ultrasounds + vibrations
Gb - 15
Operation