Fitting The Strap; Switching Off The Collar - Num'axes iki sonic User Manual

any beep sound after inserting the battery, immediately remove it from the battery holder by
using the supplied magnet (magnetic key) or by tapping briefly the case in the palm of your
hand.
- Check the polarity before inserting the battery once again. If you still do not hear any beep
sound, check the operation by switching the collar On and Off.
- Put the battery cover back in place taking care to insert first the little pin at the bottom of the
battery cover (See diagram 3).
- Retighten moderately the 2 screws.

Fitting the strap

- glide the strap alongside the case (See diagram 4)
- place the slide buckle on the strap
- attach the quick-snap buckle to the free edge of the strap
Switching On the collar
Briefly place (for less than 1 second) the magnetic key close to the orange mark located in front
of the collar.
1, 2 or 3 short beep sounds are emitted (according to the chosen mode) and indicate that the
collar has been switched on.
In the factory, the collar's mode is positioned on mode 3 (ultrasounds + vibrations).

Switching Off the collar

Briefly place (for less than 1 second) the magnetic key close to the orange mark located in front
of the collar.
1 long beep sound indicates that the collar has been switched off.
Diagram 4
Gb - 14