DD+DIS150.06E
2.2
Replacing the Cassette Edge Sensor
REQUIRED SPARE PART*:
CM+9 5175 9060 0
* The last digit in the spare part number indicates the spare
part revision at release of this document. When ordering,
the actual revision of the spare part is delivered.
REQUIRED TOOLS:
REQUIRED TIME:
30 min.
DISASSEMBLY:
(1)
Switch off the digitizer.
(2)
Disconnect the mains cable.
(3)
Simultaneously press the two buttons (A)
positioned underneath the feed table.
(4)
Pull out cassette unit (B).
(5)
Remove 3 upper screws.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2009
3 mm
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Replacements / Repair Procedures
1,5 mm
B
A
Agfa Company Confidential
Figure 42
A
Figure 43
Figure 44
Chapter 3.5 / 20