Recommended Tools - AGFA CR 30-X Service Manual

DD+DIS150.06E
1.2

Recommended Tools

Tool
Canned air
Laser Beam
Detection Toolkit
Magnifying glass 8x CM+9 9579 9904 0
Multimeter
Service PC
USB memory stick
* The last digit in the spare part number indicates the spare part revision at release of
this document. When ordering, the actual revision of the spare part is delivered.
NOTE:
As some screws are difficult to access, it is
recommended to have a 3 mm hex key with
ball-shaped head and a 6 mm magnetic hex
key in the tools assortment.
The controlled version of this document resides on MedNet. Any printed copy of this document is uncontrolled.
Edition 1, Revision 2
03-2010
Part Number*
Commercially available To remove dust from modules after
CM+9 5175 2940 0
Commercially available 
Commercially available 
Commercially available To transfer data between the
DOCUMENT CONTROL NOTE:
CR 30-X
Type 5175 / 100/110
Repair and Service
Tools and auxiliary Means
Purpose
disassembling from device.
To check and adjust the laser beam
position at digitizers manufactured
between 10/2006 and 09/2009.
To check image quality of films at the
lightbox.
To adjust the cassette edge
detection sensor.

For troubleshooting
To copy the digitizer software from
PC to CD ROM or USB stick.

To evaluate the infocounter offline.
processing station and the service PC.
3 mm,
with ball-shaped head
Figure 1
Agfa Company Confidential
6 mm (magnetic)
Chapter 3.2 / 5