Fabric Advance - Paxar 545 User Manual

Fabric Advance

Problem
Fabric does not advance
when the start button is
depressed.
Users Manual Model 545™
Probable Cause
1) No batches to be printed.
2) An interlock condition exists.
3) Feed roller(s) not gripping the
fabric.
4) Feed rollers bound.
5) Fabric bound.
6) Feed motor(s) unplugged or
faulty.
7) Thermal Control Board
unplugged or faulty.
8) Finishing Interface Board
unplugged or faulty.
Corrective Action
1) Download batch (if batch downloaded uses the
same format as a previously downloaded batch
the printer with start automatically).
1) Determine the number and type of interlock(s)
by reading the front panel display. As each is
corrected the number of errors will decrease
(Example "Error 910 Feed Open" close feed).
1) Clean the feed rollers in the active unwind and
the feed module.
1) With power off - check that all rollers turn
freely.
1) With the feed open and the pressure roller held
open in the active unwind - check that the
fabric will pull through the printer with little to
no resistance.
1) Check the feed motor cable(s) and or replace
the active unwind or feed motor.
1) Check Thermal Control Board / AT board
connection and or replace Thermal Control
Board.
1) Check Finishing Interface Board connections
and or replace Finishing Interface Board.
Electrical Trouble Shooting • 69