Chrysler neon 1997 Service Manual page 1632

SIDE RAILS
PL
REMOVAL AND INSTALLATION (Continued)
ROOF RACK CROSS RAILS
The roof rack side rail do not have to be removed
to replace the cross rails.
REMOVAL
(1) Remove screws holding cross rail to the side
rails.
(2) Separate the cross rail from the roof rack.
Fig. 83 Roof Rack Cross Rails
INSTALLATION
Reverse the preceding operation.
ADJUSTMENTS
FRONT DOOR GLASS ADJUSTMENT
UP-STOP ADJUSTMENTS
(1) Remove door trim panel.
(2) Remove water shield as necessary to gain
access to adjuster.
(3) Loosen up-stop nut.
(4) Close door and raise door glass.
(5) Adjust up-stop to achieve proper glass height.
(6) Adjust glass so that a piece of paper can be pulled
between the glass and weatherstrip with some tension.
NOTE: The top edge of the door glass should be
beneath the lip of the weatherstrip
(7) Tighten fasteners.
TOP OF GLASS—INBOARD/OUTBOARD
ADJUSTMENTS
(1) Remove door trim panel.
(2) Remove water shield as necessary to gain
access to adjusters.
(3) Using a Snap-on
loosen the lower jack-screw jamb-nuts.
(4) Close door and raise glass.
(5) Using a suitable allen-wrench, rotate jack-
screws to achieve proper in/out positioning at the top
edge of the glass.
(6) Adjust glass so that a piece of paper can be pulled
between the glass and weatherstrip with some tension.
CROSS RAILS
flare-nut socket (FRXM10),
INNER BELT STABI- IN/OUT JACKSCREWS LIZER GLASS ATTACHING NUTS
FRONT UP-STOP ROLLER CHANNEL ADJUST- REAR UP-STOP IN/OUT SCREWS JACK-
REGULATOR GLASS VIEW A
Fig. 84 Glass Adjustment—4 Door
(7) Tighten all fasteners.
Fig. 85 Glass Adjustment—2 Door
GLASS—FRONT/REAR ADJUSTMENT
(1) Remove door trim panel and water shield.
(2) Lower door glass to bottom of travel to gain
access to glass attachments. (Fig. 86)
Fig. 86 Front door glass
UP-STOP
MENT INNER BELT
GLASS
FRONT DOOR GLASS GLASS REGULATOR
ATTACHING
BODY 23 - 47
ADJUST- MENT
STABI- LIZER
VIEW B
NUTS