Chrysler neon 1997 Service Manual page 1618

BODY SIDE MOLDING TAPE ON BACK OF APPLIQUE B-PILLAR APPLIQUE B-PILLAR APPLIQUE RETAINER
PL
REMOVAL AND INSTALLATION (Continued)
Fig. 43 B-pillar Applique
B-PILLAR WEATHERSTRIP CHANNEL
REMOVAL
(1) Remove B-pillar applique.
(2) Remove push-in fasteners holding weatherstrip
to B-pillar.
(3) Pull weatherstrip from B-pillar channels.
(4) Remove screws holding channels to B-pillar
(Fig. 44).
(5) Separate channels from B-pillar.
Fig. 44 B-pillar Weatherstrip Channel
INSTALLATION
Reverse the preceding operation.
CHANNEL ROOF RAIL B-PILLAR LATCH HANDLE RELEASE PULL CUP SCREW SCREW
REAR DOOR TRIM
REMOVAL
(1) Release door latch and open door.
(2) Lower window glass.
(3) Remove window regulator crank.
(4) Remove screw from inside arm rest pull cup.
(5) Remove screw from behind inside latch release
handle (Fig. 45).
(6) Disengage push-in fasteners holding trim to
door panel around perimeter of trim panel.
(7) Disengage trim panel from retainer channel in
inner belt weatherstrip at top of door by lifting while
jiggling.
(8) Tilt top of trim panel away from door and dis-
engage clip holding latch rod to handle.
(9) Separate latch rod from handle.
(10) Separate trim panel from door.
Fig. 45 Rear Door Trim
INSTALLATION
(1) Replace any damaged or missing push–in fas-
teners from around perimeter of door trim panel.
(2) Place trim panel in position on door.
(3) Insert latch rod into handle and engage clip.
(4) Engage trim panel into retainer channel at top
of door.
(5) Locate door trim panel to inner door panel by
aligning locating pins on backside of trim panel to
mating holes in inner door panel.
(6) Engage push-in fasteners to hold trim to door
panel around perimeter of trim panel.
BODY 23 - 33