Chrysler neon 1997 Service Manual page 1505

SHIFTER/IGNITION LOCK CABLE INTER-
IGNITION KEY POSI-
TIONS
21 - 62 TRANSAXLE
REMOVAL AND INSTALLATION (Continued)
Fig. 22 Shifter Ignition Interlock Cable
STEERING STEERING COLUMN COVER (7) Pull cable up and out of the gearshift mecha- COVER LINER COLUMN
nism.
(8) Remove the three screws along the bottom of
the lower steering column cover and screw on the left
outward face of cover (Fig. 23).
(9) Grasp the cover and pull rearward until the
clips disengage.
(10) Remove two screws at the upper area of the
column liner and lower left corner.
(11) Remove steering column cover and steering
column cover liner.
(12) Lift up the top cover and cluster bezel until
the clips disengage and separate to provide clear-
ance.
CABLE ATTACHMENT LOCK INTERLOCKCABLE SHIFTER/IGNITION
OFF RUN ACC STARTADJUSTER LOCK
LEFT TRIM PANEL
Fig. 23 Lower Column Covers
(13) Insert a screwdriver into access hole in the
lower shroud. Depress the cylinder button while
rotating the cylinder with the key inserted between
the ON and START positions. This will disengage the
cylinder from the column (Fig. 24).
Fig. 24 Ignition Lock Cylinder
(14) Pull out the key cylinder.
(15) Remove the three lower–to–upper shroud
attaching screws through the bottom of the lower
shroud (Fig. 25).
(16) Separate the upper and lower shrouds.
(17) Grasp the interlock cable clip and connector.
Remove the cable from the interlock housing (Fig.
26).
(18) Unclip the cable from the retaining clip
located within the wiring harness.
RIGHT TRIM PANEL
INSTRUMENT PANEL TOP COVER
CLUSTER BEZEL
PL
AND