Installthe Lights; Attach The Emergency Release Rope And Handle - Craftsman 139.54985 Owner's Manual

INSTALLATION STEP 6
Installthe Lights
1. Pressthe releasetabs on both sides of lens. Gently rotate
lens back and downward until the lens hinge is in the fully
open position. Do not remove the lens.
2. Insert an A19 incandescent (100 watt maximum) or
compact fluorescent (26W, IOOW equivalent) light bulb
into the light socket. The lights will turn ONand remain lit
for approximately 4-1/2 minutes when power is connected.
Then the lights will turn OFF.
3. Reversethe procedure to close the lens.
4. If the bulbs burn out prematurely due to vibration, replace
with a garage door opener bulb. Use A19, standard neck
garage door opener for replacement.
NOTE:Do not use halogen, short neck, or specialty light bulbs
as these may overheat the end panel or light socket. Do not
use LEDbulbs as they may reduce the range or pefformance of
your remote control(s).
To prevent possible OVERHEATING of the end panel or light
socket:
• Use ONLYA19 incandescent (100W maximum) or compact
fluorescent (26W maximum)light bulbs.
• DONOT use incandescent bulbs largerthan IOOW.
• DONOT use compact fluorescent light bulbs largerthan 26W
(IOOW) equivalent.
• DONOT use halogen bulbs.
• DONOT use short neck or specialty light bulbs.
Release Tab
Compact Fluorescent --
Light Bulb
or
100Watt(Max)
Standard Light Bulb
lOO Watt (Max) _ _ Hinge
Standard Light Bulb "_'_%1'
CompactFluorescent
Light Bulb
INSTALLATION STEP 7
Attach the Emergency Release Rope and Handle
1. Insert one end of the emergency releaserope through the
handle. Make sure that "NOTICE"is right side up. Tie a knot at
least 1 inch (2.5 cm) from the end of the emergency release
rope.
2. Insert the other end of the emergency releaserope through
the hole in the trolley releasearm. Mount the emergency
releasewithin reach, but at least 6 feet (1.83 m) above floor,
avoiding contact with vehicles to prevent accidental release
and secure with a knot.
NOTE: If it is necessary to cut the emergency releaserope, seal
the cut end with a match orlighterto prevent unraveling. Ensure
the emergency releaserope and handle are above the top of aft
vehicles to avoid entanglement.
To prevent possible SERIOUSINJURYor DEATHfrom a falling
garage door:
• If possible, use emergency releasehandle to disengage
trolley ONLYwhen garage door is CLOSED. W eak or broken
springs or unbalanced door could result in an open door
falling rapidly and/or unexpectedly.
• NEVERuse emergency releasehandle unless garage doorway
is clear of persons and obstructions.
• NEVERuse handle to pull door open or closed. If rope knot
becomes untied, you could fall.
Trolley
Trolley
ReleaseArm
Emen
Release Handle
Overhand
Knot
17