Adjustment; Introduction - Craftsman 139.54985 Owner's Manual

Garage door opener with assure link tm connectivity
Hide thumbs Also See for 139.54985:
Table of Contents

Advertisement

Available languages

Available languages

ADJUSTMENT
Introduction
Your garage door opener is designed with electronic controls to
make setup and adjustments easy.The adjustments allow you to
program where the door will stop in the open (UP)and close
(DOWN)position. The electronic controls sense the amount of
force required to open and close the door. The force is adjusted
automatically when you program the travel.
NOTE: If anything interferes with the door's upward travel it will
stop. If anything interferes with the door's downward travel, it will
reverse.
Without a properly installed safety reversal system, persons
(particularly small children) could be SERIOUSLYINJUREDor
KILLED by a closing garage door.
• Incorrect adjustment of garage door travel limits will interfere
with proper operation of safety reversal system.
• After ANYadjustments are made, the safety reversal system
MUSTbe tested. Door MUSTreverse on contact with 1-1/2"
(3.8 cm) high object (or 2x4 laid flat) on floor.
UP (Open)
DOWN (Close)
To prevent damageto vehicles, be sure fully open door provides
adequate clearance.
ONE-PIECEDOORS ONLY
When setting the UPtravel for a one-piece door ensurethat the
door does not slant backwards when fully open (UP). If the door is
slanted backwards this will cause unnecessary bucking and/or
jerking when the door is opening or closing.
CORRECT
INCORRECT
PROGRAMMING BUTTONS
The programming buttons are located on the left side panel of the
garage door opener and are used to program the travel.
o
o
o
@
PROGRAMMING BUTTONS
f
uP
0
Button
0@,______
II
Adjustment
Button
DOWN
Button
28

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

13954985

Table of Contents