Contents Instruction Manual Product information....................Important safety instructions................... Technical specification.................... Know your machine....................Working principle....................Preparing for use....................Assembly....................... Brush selection guide.................... Controls........................Operating the machine................... Electrical diagram....................Accessories......................Upkeep of your PORT A SCRUB................Spare Parts Manual Housing - Drive Side....................Housing-Idle Side....................
Instruction Manual Product Information The Minuteman PORT A SCRUB Machine is an ideal machine to clean floors in small and medium areas like offices, hospitals, restaurants, shopping complexes and many commercial applications. It sprays plain water / detergent solution, scrubs and picks up the dirty water - all in a single pass. The Port A Scrub has different optional brushes to suit a variety of applications.
Technical Specification Description Units Specification Model M12110 Mains supply ± 100-110 VAC 10% 60Hz, Single Phase Power 750+26 Brush Speed Cleaning Capacity ft /hr 3,800 Cleaning width inch 12.5 Fresh water tank capacity gallon Overall dimensions Height with handle 43.75...
Know your machine Top handle Liquid discharge control handle (3) Tank (4) Bottom handle (5) Dirty water tank (6) Filter (7) Lid Cap (8) Boot (9) Nozzle (10) Conveyor drum (11) Brush (10) (12) Pedal (11) (12) Working Principle 1. Cleaning liquid in the fresh water tank is made to spray on the floor to be washed.
Assembly 1. Insert the two tubular handles into the bottom handle and secure them using knob (2 Nos) by tightening lightly. Ensure that the handles are assembled according to their marked position and the cable holding hooks are pointing towards the rear. 2.
Controls On/Off Control By pressing the pedal lightly with your foot, pull back the handle a little to start the motor. The brushes and the drum starts rotating. Pulling the handle further without pressing the pedal, lowers the machine and engages the rotating brushes onto the floor. To stop working, take the handle to the vertical position.
3. Stop the liquid discharge approximately one foot before the end of forward motion. continue to move forward up to the wall without pulling the pull handle . (a) Nozzle at normal position (b) Nozzle at rotated position Spray angle / area can be controlled by the user according to their (c) Nozzle inserted inside the holder at rotated position (iii)
Accessories Transporter The simply fitted trolley provides for ease of movement when transporting the machine. Installing the Transporter 1.With the machine handle in the upright position place the transporter centrally alongside the machine. 2.By holding the machine firmly, strap the velcro with the machine to fix the transporter. 3.Ensure that the velcro strap properly wrapped around the bottom handle.
Lever and Guide Link Mechanism Ref. Part Description Size 925104 CRPH SCREW M4x12 925008 CLEVIS PIN 925014 CLEVIS PIN 925043 LINK 925053 SHIELD 925055 LEVER 925105 LEVER BUTTON 925129 CIRCLIP 925139 LINK GUIDE 925180 SPRING 925212 BUSH 925810 WHEEL 925822 LEVER ASSY 118a 925085...
HEX SHAFT 925068 WASHER 925078 TIE ROD 925079 SHAFT 925081 ROLLER 925099 O' RING 925108 BUSH 925112 BUSH 925113 BUSH 925808 BRUSH SHAFT 925067 DRUM ASSY 134a 925070 DRUM 134b 925071 DRUM SLEEVE 925762 MOTOR (M12110) 925761 MOTOR (M12230) 928548 BRIDGE...
Page 24
Accessories Transporter Side Brush Assy...
In addition, Minuteman International, Inc will, at its option, honor labor warranty claims for the first 6 months from date of sale, provided such claims are submitted through and approved by factory authorized repair stations.