Assembly; Brush Selection Guide - Minuteman M12110 Instruction Manual

Assembly

R I G H T
B O T T O M
R E A R
L E F T
B O T T O M
R E A R

Brush Selection Guide

Type of floor
All natural stone floors,
Ceramic, Mosaic, Wood,
Profiled rubber, Vinyl, PVC,
Short pile carpet
Marble Granite
Smooth concrete
Escalator
Others
Brush identification
This is applicable when the customer has more than one set of brushes of same type.
Example : 2 or more sets of Standard Brush
Customers may not interested to use same brushes in Bedroom / Kitchen / germ free
area which is already been used in other areas like Corridor / Bathroom / Oil or
chemical deposited areas. It is difficult for the customers to identify the particular
brush which is used in certain area. To make this easy, Brush buttons of colors RED,
BLUE, WHITE and YELLOW are packed with the machine. Customers shall plug the
buttons on the hole provided in the brush as shown. This helps the customer to
identify the particular brush by keeping the button (color) as reference.
6
1. Insert the two tubular handles into the bottom handle and secure them using
knob (2 Nos) by tightening lightly. Ensure that the handles are assembled according
to their marked position and the cable holding hooks are pointing towards the rear.
2. Slide the electric cable retainer into the top portion of RH handle.
3. Fit the top handle over the tubular handles and secure them with washer and
screw (2 sets). Ensure that the label on the top handle is facing the front of the
machine. Now tighten firmly both the knobs and screws alternately. Insert the
dummy caps provided to cover the screws (2 nos) in the top handle.
4. Pass the free end of the pull cable through the plastic guide in RH Handle.
5. Fix the auxillary tank firmly into the bottom handle by holding the top handle.
6. Rotate the knob to hold the auxillary tank.
7. The brushes are only loosely packed in the machine for transit, therefore the
brush shafts must be fitted before operating the machine. Push the shafts through
the brushes from the side of the machine. To remove brushes, push the brush shaft
out from the side of the machine using the fingers and withdraw the shaft. Normally
standard brush type will be supplied with the machine. Brushes shall be selected
according to the type of floor surface to be cleaned, and the degree of dirt to be
removed, please refer Brush Selection Guide.
8.Now machine is ready for use.
First time cleaning
Standard
Soft
Soft
Hard
Escalator
To suit individual floor conditions
Maintenance cleaning
Soft
Soft
Soft
Standard
Escalator
Refer Page 25 for Brush Selection
(a)
(a) Hole provided for plugging button.
(b) Brush with button plugged.
(b)