Instruction Manual; Product Information; Important Safety Instructions - Minuteman M12110 Instruction Manual

Instruction Manual

Product Information

The Minuteman PORT A SCRUB
medium areas like offices, hospitals, restaurants, shopping complexes and many commercial applications. It
sprays plain water / detergent solution, scrubs and picks up the dirty water - all in a single pass. The Port A
Scrub has different optional brushes to suit a variety of applications. This machine can be used only on smooth
even floors like Mosaic, all type of stone floors, PVC, Short-pile carpet, Wood and Profiled Rubber. It should not
be used on rough uneven surfaces. .

Important Safety Instructions

Please read the following instructions completely before operating the machine. Any violation of the
same will not only invalidate the warranty, but also may result in a safety hazard.
The machine must be unpacked and assembled in accordance with these instructions before connecting to
the electrical supply.
·
This machine should always be connected to a fully grounded power supply of the right voltage and
frequency.
·
Keep the power supply cord away from moving parts. During operation, hazard may occur when running
machine over the supply cord.
·
The machine must be disconnected from the mains supply (by pulling the plug out) before changing the
brushes, cleaning the machine and, for maintenance.
·
Warning! Use only the brushes/accessories strictly as per the instruction manual. Usage of any other
brushes/accessories can cause safety problems.
·
Periodically inspect the cord for possible damage. The damaged cord must be replaced with the special cord
available from the manufacturer or an authorized service agent.
·
DO NOT leave the machine connected to the power supply when not in use; always remove the plug from
the mains socket.
·
DO NOT use where hazardous dust is present.
·
DO NOT use machine near flammable liquids.
·
DO NOT use in an explosive atmosphere.
·
DO NOT use in gradient surface.
·
DO NOT keep the machine with handle lowered, when the machine is in working mode.
Guidelines for the operator
·
Operators must be fully trained in accordance with these instructions, able to perform routine upkeep of the
machine and correct selection of brushes.
·
Operators should be physically capable to maneuver transport and operate the machine.
·
DO NOT run the machine dry, as this could damage the floor surface or the machine itself.
·
Take adequate care to hold the machine firmly while installing and removing the brush.
·
Never use excessive foaming or highly corrosive cleaning solutions.
·
While operating on a flooded floor, always ensure that the water level does not exceed 1/4".
·
DO NOT operate this machine on rough uneven surface like industrial concrete floor.
·
Do not clean the machine using water jet.
·
Ensure all parts are fitted properly before operation.
Machine is an ideal machine to clean floors in small and
3