Servicing - Blanco CG604WXC Instruction Manual

5) SERVICING

WARNING:
S e r v i c i n g s h o u l d b e c a r r i e d o u t o n l y b y
authorised personnel.
10) COMPONENTS REPLACEMENT
NOTE:
B E F O R E A N Y M A I N T E N A N C E R E Q U I R I N G
R E P L A C E M E N T O F A C O M P O N E N T I S
U N D E RTA K E N
ELECTRICAL LEAD HAS BEEN ISOLATED AND
REMOVED FROM THE POWER POINT.
To replace the components fit inside the hob is
necessary to take off the pan supports and the
burners from the upper part of the working table,
then unscrew the burner fixing screws "V" (fig. 16)
and the control knobs, fixed by a simple pressure,
in order to take off the working table.
After having carried out the above listed operations,
the burners (fig. 17), taps (fig. 18) and electrical
components can all be replaced (fig. 19).
It is advisable to change seal "D" each time a tap is
changed in order to ensure a perfect tightness.
FIG. 16
17
E N S U R E T H AT
Greasing the taps (see fig. 20 - 21)
If a tap becomes stiff to operate, it must be
immediately greased in compliance with the
following instructions:
- remove the tap.
- Clean the cone and its housing using a cloth
soaked in diluent.
- Lightly spread the cone with the relative grease.
- Fit the cone back in place, operate it several
times and then remove it again. Eliminate any
excess grease and check that the gas ducts
T H E
have not become clogged.
- Fit all parts back in place, complying with the
demounting order in reverse.
To facilitate the servicing technician's task, here is
a chart with the types and sections of the powering
c a b l e s a n d t h e r a t i n g s o f t h e e l e c t r i c a l
components.
FIG. 17 FIG. 18