NordicTrack club cr NTL49008.0 User Manual page 33

Table of Contents

Advertisement

PROBLEM: The walking belt is off-center or slips when walked on
SOLUTION: a. If the walking belt is off-center, remove the key and
UNPLUG THE POWER CORD. If the walking belt
has shifted to the left, use the hex key to turn the
left idler roller bolt clockwise 1/2 of a turn; if the walk-
ing belt has shifted to the right, turn the left idler
roller bolt counterclockwise 1/2 of a turn. Be careful
not to overtighten the walking belt. Plug in the power
cord, insert the key, and run the treadmill for a few
minutes. Repeat until the walking belt is centered.
b. If the walking belt slips when walked on, first remove
the key and UNPLUG THE POWER CORD. Using
the hex key, turn both idler roller bolts clockwise, 1/4
of a turn. When the walking belt is correctly tight-
ened, you should be able to lift each edge of the
walking belt 3 to 4 in. (8 to 10 cm) off the walking
platform. Be careful to keep the walking belt cen-
tered. Then, plug in the power cord, insert the key,
and carefully walk on the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
PROBLEM: The incline of the treadmill does not change correctly
SOLUTION: a. The incline system may need to be calibrated. To initiate the calibration routine, switch the
reset/off circuit breaker to the off position, wait 5 seconds, and then switch the circuit breaker back
to the reset position. During the calibration routine, the treadmill will automatically travel to the
highest incline level and then return to the initial level.
b. If the incline system still does not function properly, please see the front cover of this manual.
PROBLEM: The remote control does not function correctly
SOLUTION: a. Make sure you are standing on the treadmill, holding the remote control near the television and
pointing the remote control directly at the console.
b. If your remote control is still not functioning correctly, the batteries should be replaced; most re-
mote control problems are the result of low batteries. See page 27 to replace the batteries.
a
b
33

Advertisement

Table of Contents
loading

Table of Contents