Table of Contents
Advertisement
HOW TO OPERATE THE PERSONAL TELEVISION
IMPORTANT: Before operating the television, you
must connect the 96" AV Cable or a CATV cable to
the treadmill (see page 13).
1. Turn on the television.
If there is a sheet of clear plastic on the television
screen, remove the plastic. Insert the key into the
console. See step 1 on page 17. Press the TV
power button (see page 27) to turn on the televi-
sion. Note: If you operate the television without in-
serting the key into the console, the buttons on the
console will not function.
2. Scan for television channels.
Before operating your television, you must scan for
channels. See page 29 for information about scan-
ning for channels. Note: To use a VCR or DVD
player, you must connect a VCR or DVD player
and then scan for channels.
Your television can receive analog and digital sig-
nals. For the television to operate properly, good
reception is necessary. Make sure the television
settings are set correctly (see HOW TO ADJUST
THE TELEVISION SETTINGS on page 28). If you
are using an antenna, make sure that it is properly
connected and adjusted for optimal reception (see
HOW TO CONNECT AN ANTENNA on page 13).
3. Press the Input button to select a television
source.
Select a television source by pressing the Input
button repeatedly. If you have connected an an-
tenna or a 75 ohm CATV cable to the 75 ohm ter-
minal on the treadmill, select the TV source. If you
have plugged the 96" AV Cable into the
audio/video input jack, select the AV source.
To use a VCR or DVD player, make sure the VCR
or DVD player is connected correctly (see page
13). Select the AV source and press play on your
VCR or DVD player.
4. Press the Channel buttons to select the desired
channel.
When you turn on the television, the screen will
show the last channel that was selected. To select
a different channel, press the numbered channel
buttons on the remote or the Channel increase and
decrease buttons. The selected channel number
will appear on the screen for a few seconds. Note:
Before channels can be selected, they must be
saved in the televisionʼs memory. See page 29.
5. Press the Volume buttons to adjust the volume.
Press the Volume [VOL] increase or decrease but-
tons on the console to change the volume. Note:
For best results, change the volume by pressing
the Volume buttons on the console only. Make
sure the audio wire is not plugged into audio jack
on the console.
To use earphones or headphones (not included),
plug them into the headphone jack near the Start
button on the console.
6. Turn off the television.
When you are finished using the television, press
the TV power button to turn off the television.
26
Advertisement
Table of Contents
